Introduction

maXpeedingrods' MXR-B1 series is ideal for those who want to change the old worn-out strut but improve handling at the same time. It features height adjustable and maintains the OE ride quality to the greatest extent.

Application

Compatible for VW POLO V (6R_, 6C_) 03 / 2009- hatchback
compatible for AUDI A1 (8X) 8X1, 8XK 05 / 2010-10 / 2018 hatchback
compatible for AUDI A1 Sportback (8X) 8XA, 8XF 09 / 2011-10 / 2018 hatchback
compatible for SEAT IBIZA IV (6J5, 6P1) 03 / 2008-12 / 2017 hatchback
compatible for SEAT IBIZA IV SPORTCOUPE (6J1, 6P5) 06 / 2008-12 / 2018 coupe
compatible for SEAT IBIZA IV ST (6J8, 6P8) 03 / 2010-07 / 2016 station wagon
compatible for SKODA FABIA NJ 2014+

Specification

Top mounts: Front and rear OE top mounts required
Damping adjustable: Not available
Camber adjustable: Not available
Height adjustable: Yes, lowering 0-25mm depending on the vehicle models
Spring rate Front: 8 kg/mm (448 lbs/in)
Spring rate Rear: 3.5 kg/mm (196 lbs/in)
Front spring inner diameter: 62 mm
Rear spring inner diameter: 63-64 mm
Spring length Front: 170 mm
Spring length Rear: 225 mm
Help spring rate Front: 1 kg/mm (56 lbs/in)
Help spring length Front: 102 mm
Spring Preload advised: 7-10 mm
Color: Silver body with gold spring

Package included

Package included：
2x Front coil-overs
2x Rear coil-overs
2x C spanners

Dimension

Package size : 70*50*20 cm
Weight: 20000 g

Feature

1. 0-25mm(depends on vehicle models) lower height adjustable

2. Dust boot, solid rubber bump stops

3. Aluminum components and steel lower mount brackets designed to balance weight and structural requirements.

4. Simple install, Easy to adjust.

5. Use the vehicle's original upper mounts (not included in our product kit).

Note

1. All modifications must be installed by licensed mechanics and in compliance with your local modification regulations.

2. Please ensure all components are tightened with correct torque specifications (which can be found in the vehicle service manual)before and after installation. Any loose nuts, bolts, or locks will cause noise. Do check and tighten before serious problems happen.

3. Impact wrench is prohibited during the installation, it will loosen or damage the product.

4. Examine the clearance between tires and suspension. ( The minimum clearance should be 4mm, otherwise, you need to add wheel spacers. Caution: It is not sufficient with torsion beam trailing arm axles)

5. Regular maintenance is recommended for the coil-over. Applying WD-40 or a suitable protective spray every 3–4 months can help keep the components clean and moving smoothly.